Black ops- covert

[Krivoman]

I am getting signal, it starts the searching network, then after about a minute or so it says login fail... I used this camera in this same location last week....

[drop dead fred]

Turn off pull SIM card try again?

[Reel Screamer]

Re insert you start up card again. If not, do complete new download

[Fishndude]

Manual says "make sure SIM card isn't locked"! I didn't know you could lock a SIM card.

[Lip]

I had the same problem and it turned out my SIM card wasn't active.

Now they're running but I'm getting a lot of false triggers during the heat of the day. I adjusted them to >80 deg and it reduced the false triggers but I'm still getting them on one camera. They were mounted on small trees which moved a lot in the wind but now on t-posts. Guess I need to find something more stable than the t-post I mounted one on to eliminate the false triggers.

[bermise]

Wow, these cams are full of troubleshooting. There's a new thread about it everyday. Hope it works out

[Archery1st]

If you have the same SD card with the download on it and get login failed. Go ahead and turn it on and it will continue to try and login and you will probably get a picture on the first deer in. Josh's camera does this ever other time.

[Krivoman]

I was getting allwhite pictures last week cause battery was down to 35%. So i swapped batteries and could not get it to work this time... Will try the sim card in and out....

[Archery1st]

I had the same problem and it turned out my SIM card wasn't active.

Now they're running but I'm getting a lot of false triggers during the heat of the day. I adjusted them to >80 deg and it reduced the false triggers but I'm still getting them on one camera. They were mounted on small trees which moved a lot in the wind but now on t-posts. Guess I need to find something more stable than the t-post I mounted one on to eliminate the false triggers.

These cameras are super sensitive. I think they come set to high or medium. Set the detection sensitivity to low and false triggers will reduce significantly. Its the heat..any blowing brush grass in the field of view will increase false triggers as well when temps get over 90.

[elkbowhunter]

Never had an issue with mine. The issues I had have always been my fault...not the camera.

[Electrican]

Wow, these cams are full of troubleshooting. There's a new thread about it everyday. Hope it works out

My thoughts as well!

[Abcdj]

I am running two with no problems unless it's operator error.

[elkbowhunter]

i am running two with no problems unless it's operator error.

this x1000

[elkbowhunter]

I was getting allwhite pictures last week cause battery was down to 35%. So i swapped batteries and could not get it to work this time... Will try the sim card in and out....

Never seen a COVERT with 35% battery level indicator.
Battery visual is numbered with 1 through 10. How did you come up with 35%??