Arggg

[ramos104]

Picked up a new sx3 today put it together and blah blah blah. Pretty simple. Went to dry fire it and nothing. No click, nada. Did I do something wrong

[ramos104]

Anyone??

[ramos104]

Ttt

[Witchgrass]

What's an sx3? Am I the only one that doesn't know what that is?

[Colton]

What's an sx3? Am I the only one that doesn't know what that is?

x2

[jck]

It's the Winchester SX3...a shotgun.

As far as not clicking, i haven't a clue. Take it apart again and look it over and put it back together?

[Buckshot-73]

What's an sx3? Am I the only one that doesn't know what that is?

Nope, your not the only one.

Perhaps it is a new frisbee launching system.

[talltexasshoote]

Bolt is probably not all the way forward. Pull it back and push the release button. Let it slam forward. Then try it.

[Colton]

Bolt is probably not all the way forward. Pull it back and push the release button. Let it slam forward. Then try it.

If all else fails, take it to a gunsmith

[ramos104]

If all else fails, take it to a gunsmith

Either taking it back to academy tomorrow or a gunsmith

[rebelmdb69]

My guess is assembled wrong. I have an SX2 and SX3 and did it the first time with my 2.

[berettadave]

I bet the barrel is not seated completely. If that's the case, it wont let the bolt lock up tight enough and the firing pin won't strike the primer. I've messed with several of them and they seem to work fine normally. I remember they can be a little finicky about assembling them. Once you get it down, it's pretty simple. If I remember correctly, I had to kinda move the bolt closer back and forth a little while sliding the barrel in place. It's been a while since I've messed with them.

Dave