Hey Machinist out there.

[coker737]

Looking to make some hand holds for my Mule outa 1" Open End/Box End Wrenches. Need to drill a 3/8 hold at each end. Going to include 1/2 sleeves for spacing.

Question is what type drill bit to cut through these?

[UncleBubba]

Any 3/8" drill will work, just make sure its not a wood bit. PM me if you have any issues. Our shop is in Greenville but you are welcome to bring it out and I'll drill them for you. If you can find a local shop they shouldn't charge more than $25-30 to drill them for you. Good luck!