Announcement

Collapse
No announcement yet.

How do you stake down a feeder?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    How do you stake down a feeder?

    Some feeder legs have a hole in the leg base to stake it down. How do you stake it down if it doesn't have the hole? Thanks...

    Sorry I'm a noob with feeders.

    #2
    try driving a T-post at each leg and tying the feeder legs off the the T-post.

    Comment


      #3
      T-post and wire. Pound the t-post into the ground and wrap wire around the leg of the feeder and t-post.

      Comment


        #4
        Originally posted by scissorhands View Post
        T-post and wire. Pound the t-post into the ground and wrap wire around the leg of the feeder and t-post.
        This. Hasn't let me down yet

        Comment


          #5
          Originally posted by Lucky13ranch View Post
          try driving a T-post at each leg and tying the feeder legs off the the T-post.
          ^^^this

          Comment


            #6
            Smallest T-Post suffice? I just don't want the dang piggies knocking it over.

            Comment


              #7
              I actually use u-post and then take a metal screw clamp (small dryer hose clamp) and wrap around the post and the feeder leg. Hasn't failed me yet.

              Comment


                #8
                4' pieces of 5/8" rebar driven in 2' works nicely too.

                Comment


                  #9
                  T-post, I drill a hole in the legs, then I use barbwire minus the barb to secure it.

                  wee

                  Comment


                    #10
                    A solid 3' tpost or large rebar will work fine. I like to drive mine in straight down about a foot up the leg and tie the leg to it with bailing wire. If you leave too big of a gap between the two, a hog can push them apart, even on a well built tripod feeder. It happened to my hard headed uncle this summer, it was funny watching hogzilla muscle the leg loose and tump his big old feeder over.

                    Comment


                      #11
                      T-post running along the angle of the legs in case you fall you wont be impaled

                      Comment


                        #12

                        Comment


                          #13
                          same as above rebar and bailing wire

                          Comment


                            #14
                            One thing to be careful about--filling feeders from a ladder. I was 2/'3rds of the way up the ladder w/50 lbs of corn over my shoulder and the stepladder kicked out from under me. Hit the ground hard, corn sack burst open, but thankfully I didn't land on one of the stakes. I angle mine out rather than in to at least keep them from being directly under the feeder barrel.

                            Comment


                              #15
                              Originally posted by dustoffer View Post
                              One thing to be careful about--filling feeders from a ladder. I was 2/'3rds of the way up the ladder w/50 lbs of corn over my shoulder and the stepladder kicked out from under me. Hit the ground hard, corn sack burst open, but thankfully I didn't land on one of the stakes. I angle mine out rather than in to at least keep them from being directly under the feeder barrel.
                              A week ago today I had a friend do the same thing only he wasn't so lucky. He was impaled on a T post and is lucky to be alive. He's still in the hospital and likely will be for a while. If you use stakes, cut 'em off short. Put a cap on them. Better yet, do both.

                              Comment

                              Working...
                              X