SolidWorks

[Jaybo31]

I used to be the Design Supervisor next door at Brandt for 8 years. I left in 2004. Used to come over and help setup your Autocad menus and do your customization and work on your computers. We were using Inventor and TOT had just switched to Solidworks. I now have to do 3D in Autocad, but it is all driven by customized menus, so it is not to bad. Not anywhere as close as Inventor or Solidworks.

I remember you. I was a leadman in assembly at that time. Is your name Keith? You were pretty much all purpose IT too lol. That was back when we had no IT department.

[Bearkat]

I remember you. I was a leadman in assembly at that time. Is your name Keith? You were pretty much all purpose IT too lol. That was back when we had no IT department.

That is me. I now manage a design department for XTO Energy (ExxonMobil). Don't have to do as much IT anymore, but still do the design work. I remember you, also. I Used to have to come down and work on some shop equipment. Good to here from you.

[TimH]

I've installed it a couple hundred times along with ProE for our Eng. at work. That's all I can say about that.

[Jaybo31]

That is me. I now manage a design department for XTO Energy (ExxonMobil). Don't have to do as much IT anymore, but still do the design work. I remember you, also. I Used to have to come down and work on some shop equipment. Good to here from you.

You too! Small world. TOT is now in a 150,000 sqft building with a couple hundred employees