Need Some Metal Cut in Dallas

[Throwin Darts]

I bought a hitch hauler for my Jeep and my after market bumper causes the 2 inch receiver to be too shallow to receive the hitch hauler. I need about an inch cut off of the hitch hauler insert pole so that the pin hole lines up.

Is there someone in Dallas that has a torch that can help me cut an inch or so off of the hitch hauler sometime before Thursday? Or does anyone know of a shop around town that does this kind of thing?

Thanks

[Ol Thumper]

Surely someone will help out, if you were closer Id gladly do it for you but worst case scenerio is you buy a cheap hack saw and do it yourself Im sure its just 14g metal so not to big of a job.

[Todd-ty729]

My shop is near Royal Ln. and I-35.

I can help you out on this whenever you can get over.

[keep]

If you ever get over the west Ft Worth I can do it easily. You're welcome to stop by if you can't find anyplace close but with the cost of fuel it may be cheaper to pay someone to cut it off than drive here. Anyway, offer stands.

[Txjourneyman]

I'm at the university of Dallas in Irving every day 6AM to 4 PM. I can do it with a band saw.

[Shake1]

These guys will do it for you. I've used them on several welding projects. They are inexpensive and quick on the turnaround. Located just north of Carrollton area.

http://www.mcgillprop.com/

[CletusBodeen]

Hack saw or a cheap import chop saw will do the trick

[125Dad]

I would take it to ty 729. He will do it for you and all you will have to do is watch trust me i take stuff to him all the time.

[jgard]

im in the rockwall area i can do i if needed