Where to get 6 inch PVC?

[blacksunshine]

Where to get 6 inch PVC?

[buckybill]

plumbing supply store there is a ferguson supply there in your town they can get your 6 inch pipe for you

[Huntindad]

try craig's list

[Bill]

Irrigation supply places. I got my 6" pvc to build a shipping 'tube' for my recurve bow at one out here.

[stuntriderant]

Ferguson for sure. Its behind the furrs on 35 and 71.

[VorTexan]

Irrigation supply places. I got my 6" pvc to build a shipping 'tube' for my recurve bow at one out here.

Don't know what you are using it for but PVC is expensive!

Go to a water supply/sewer company and save.

I bought it real cheap one time and never bought reg PVC again for the large stuff.

[Uncle Saggy]

Don't know what you are using it for but PVC is expensive!

Go to a water supply/sewer company and save.

I bought it real cheap one time and never bought reg PVC again for the large stuff.

Yes. PVC is through the roof. Just paid $900 for 10' of 12" and right at a grand for the elbows

[blacksunshine]

Yes. PVC is through the roof. Just paid $900 for 10' of 12" and right at a grand for the elbows

holy crapola batman!

I wanted to build another rod tube, 4 inch is rather small...but on the other hand, I can still cram a few rods in each one, tube and end pieces were under $20....


saw some 6 inch fittings there and had never seen 6 inch at home depot much less the fittings...so figured that would better suit my needs...might be able to cram almost all my rods in one of those...

[Arrowsmith]

holy crapola batman!

I wanted to build another rod tube, 4 inch is rather small...but on the other hand, I can still cram a few rods in each one, tube and end pieces were under $20....


saw some 6 inch fittings there and had never seen 6 inch at home depot much less the fittings...so figured that would better suit my needs...might be able to cram almost all my rods in one of those...

I have got some used (old storm drain that we dug up) that you can have.

pm me if you want it.

[bigmike]

where are you? try an irrigation or water well supply place and tell them what youre doing , they may have some broken , or messed up joints they will give you , i got some free 10" that way , i only needed 6 ft

[mataconfletcha]

dont have a clue where you are at but if near Katy I can get a couple of ten foot sections for ya but it is the grey type-electrical

[Uncle Saggy]

I bought schedule 80, but the 12" 40 was also bad high.
Go get drainage/vent pvc. Thats what I make tube feeders from and it's cheap

[Todd-ty729]

Get thin-wall pipe. Less money and plenty strong enough to do what you want.