All my current set ups are tent blinds. I had a couple of shot opportunities this weekend on late moving deer but their time of arrival coupled with the darkness of the tent was not a good combination. I think I could probably hunt 10 or 15 minutes longer with a lighted sight. What are the pros and cons?
Announcement
Collapse
No announcement yet.
Pros and Cons of Lighted Sights
Collapse
X
-
I have a battery powered one and it is TOO bright. But there is an easy solution. I accidently left it on and ran the batteries down. So I only use 1 battery that is good and 1 that is dead. Then it is still pretty bright.
Get some black eletrical tape and put over the LED bulb housing, then I get a hot needle and burn little holes in the tape for tiny pin holes. I burned the holes in a linear fashion to cast the light on several pins ... seemed to do the trick.
Comment
-
Originally posted by orion View PostI am a fan of lighted sights and have used them before-
the only con i know is that a buck cannot be registered as a P&Y with certain lighted sights.
Comment
-
The light for my Axcel Armortech is nice and does not have a halo effect either. It is a white light instead of purple or blue and is not noticeable viewing from the front. It's also has a 3-stage setting for brightness. However, the pins are bright enough that I seldom even need the light at all
Comment
-
Pro: Can see pins.
Con: Come to full-draw and realize you forgot to turn it on.Ultramatic Feeders
We're paratroopers, Lieutenant. We're supposed to be surrounded......
/l _ ,[____],
l---- L-- -OlllllllO-
()_)--()_)---o-)_)
Comment
-
Originally posted by UncleCharlie View PostAll my current set ups are tent blinds. I had a couple of shot opportunities this weekend on late moving deer but their time of arrival coupled with the darkness of the tent was not a good combination. I think I could probably hunt 10 or 15 minutes longer with a lighted sight. What are the pros and cons?
I personally like a single up pin, HHA 5519 with their afterburner fiber light, has a rheostat for changing light conditions. Another pro(for me) of using a single up pin, is sometimes in low light, it is enough to just use the silhouette of the pin, and having only one to pick out is a plus.
Another good rule of thumb with pin lights, is stick to smaller diameter fibers, larger fibers tend to flare, usually obscuring your view of the target.
Comment
Comment