Measuring arrow length???

[krisopp]

When measuring arrow length, do you measure it with the nock or without? I feel like I should have already known this... -Kris-

[Rsatt]

measure it to the inside of the nock(where the string fits in the nock)

This is the official way I was told.

[Codypatt1]

I have always thought you measure from center of nock to end of bare shaft unless you clarify it is "bare" shaft measurement.

[rocky]

Bottom of nock groove to end of shaft.

[krisopp]

Thanks my peeps! That's what I was thinking, but I wasn't sure.

[Mike Javi Cooper]

Bottom of nock groove to end of shaft.

Yep, unless you are using one of the shaft selector programs... like OnTarget2 then it is usually bare shaft only.. no nock..

[rocky]

Yep, unless you are using one of the shaft selector programs... like OnTarget2 then it is usually bare shaft only.. no nock..

I'm not that advanced, I just use a saw setup to cut using a measurement from the bottom of the nock groove.